Topic Path


Slitters

Slitter for Battery Materials

Slitter for Battery Materials such as lithium battery electrodes is designed to cut battery materials (cathode, anode materials, separators) with a high degree of accuracy.
It has a high-precision cutter stand which improve the cutting quality by controlling with numerical values and a new mechanism. Blade type is selectable depend on characteristics of your materials.

Slitter for Battery Materials

Features

High-precision cutter stand enabling stability in cutting battery materials

Precisely controlling the positional relationship between the blade and material in increments of micrometer units, it can reduce generating base material burrs and powder for cutting battery materials which having different properties combined.

Balancing quality and cost by selecting the cutting method

This slitter can respond to two blade combination types of Gang and Goebel without the need for replacement of parts. By using both combinations according to difference in properties between anode materials, cathode materials, and separator, stable high cutting quality and cost reduction can be balanced.

Cutting method

Goebel

Gang

Working details can be controlled by setting numerical values.

Original machanisms and mesurement control technologies are equipped. It enables a high reproducibility and a stable cutting quality that is not dependant on a visual check and feeling.

Blade easily combined by extendable cutter shaft

An "extendable cutter shaft" is a mechanism for fixing the blade by extending the shaft diameter by hydraulic pressure.
Rattling when attached is small and variation in the lap amount due to vertical deviation of the blade can be prevented.
The diameter of the shaft is decreased to make insertion and removal easy, when the blade is combined.(Extendable cutter shaft patent pending)

Thermal expansion during operation automatically adjusted

It measures thermal expansion during operation at each shaft bearing mechanism of the upper and lower cutter shafts.
When a deviation in the thrust direction between both blades is generated, the position of the shaft is controlled in increments of micron units to keep the cutting quality at a high level.

Specifications

*Spec of DA700 is shown below as a sample of this type.

Processing material: Battery materials (cathode, anode materials, separator)
Applicable sheet thickness: Total thickness 0.05~0.2mm
Maximum sheet width: 700mm
Maximum source coil weight: 300kg
Source coil inner diameter: φ3 inches (φ76.2mm core inner diameter)
Maximum source coil outer diameter: Φ700mm
Maximum rewinding coil weight: 300kg
Rewinding coil inner diameter: φ3 inches (φ76.2mm core inner diameter)
Maximum rewinding coil outer diameter: Φ700mm
Line method: Whole tight, drive cut, slip winding
Line speed: MAX 100m/min
Cutter type: Gang/Goebel
Material holder: Ring finger, concentric rubber, roll holding method
Winding method: dual shaft individual rewind friction
Apparatus size: W6500×H2050×D2600mm
Power facility: 200V AC Three-phase 50/60Hz 22kVA

* Coating mainly consisting of metal foil and electrode composite materials by lamination are assumed.
Thickness of sheet to be processed and wound coil outer diameter may vary depending on meterial.


Standard equipment composition

Un-coiler
Tension pickup
EPC device
Bridle roll

Cutter stand

Electric near roll (2 shafts)
Recoiler (2 shafts)

Scrap winder (2 shafts)
Electric device


Jig tool/consumable parts

Cutter, Cutter spacer,
Ring finger, Winding core


Options

Entry-side and exit-side material handlings
Attachment for adjusting source coil inner diameter
Suction nozzle for contamination, Cutter cleaner
Pass line angle adjustment mechanism


Contact

Please use an contact form to request a trial cut or make an inquiry about this slitter.

Request/Inquiry

↑ Top of Page


Page-list